74
Using the viewfinder
Turn the LCD panel over and fold it back into the camcorder body with the LCD screen
facing out. You can operate camera brightness and fader on the touch panel using the
viewfinder.
The POWER switch should be set to or .
Operate by touching the panel.
(1) Turn the LCD panel over and move it back to your camcorder body with the
LCD screen facing out, then pull out the viewfinder.
(2) Press
OFF. The PANEL OFF indicator appears on the screen.
(3) Press OK. The LCD screen is turned off.
(4) Looking in the viewfinder, press the LCD screen. EXPOSURE,
OK, ON
and FADER (only when the POWER switch is set to CAMERA) appear.
(5) Press the LCD screen and select the desired item, then press
OK.
EXPOSURE:
Adjust the exposure by pressing –/+.
FADER:
Press FADER until the desired fader mode appears.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE
Rr
(no indicator) T DOT T WIPE T OVERLAP
ON:
The LCD screen lights up.
To Next Page
Loading...
Need help?
General
