128
Self-timer memory photo recording
You can record images on “Memory Stick”s with the self-timer.
You can use the Remote Commander for this operation.
(1) Set the POWER switch to MEMORY. Make sure that the LOCK switch is set to
the left (unlock) position.
(2) In the standby mode, press MENU to display the menu settings.
(3) Turn the SEL/PUSH EXEC dial to select SELFTIMER in
, then press the
dial.
(4) Turn the SEL/PUSH EXEC dial to select ON, then press the dial.
(5) Press MENU to make the menu settings disappear.
(6) Press PHOTO deeper.
Self-timer starts counting down from 10 with a beep. In the last two seconds of
the countdown, the beep gets faster, then recording starts automatically.
To record moving pictures on “Memory Stick”s with the self-
timer
Press START/STOP in step 6. To cancel recording, press START/STOP again.
To cancel self-timer recording
Set SELFTIMER to OFF in the menu settings while your camcorder is in the standby
mode. You cannot cancel self-timer recording with Remote Commander.
Note
The self-timer recording mode is automatically canceled when:
– Self-timer recording is finished.
– The POWER switch is set to OFF (CHG) or VCR.
To check the image to be recorded
You can check the image by lightly pressing PHOTO, then press it deeper to start self-
timer recording.
Recording still images on “Memory Stick”s
– Memory Photo recording
4
CAMERA SET
SELFTIMER
D ZOOM
STEADYSHOT
RETURN
OFF
ON
[
MENU
]
:
END
PHOTO
MENU
PHOTO
To Next Page
Loading...
Need help?
General
