32
You can use these buttons to check the recorded picture or shoot so that the transition
between the last recorded scene and the next scene you record is smooth.
END SEARCH
You can go to the end of the recorded section after you record.
In the standby mode, press END SEARCH.
The last five seconds of the recorded section are played back and your camcorder
returns to the standby mode. You can monitor the sound from the speaker or
headphones.
EDITSEARCH
You can search for the next recording start point.
In the standby mode, hold down the +/– 7 side of EDITSEARCH. The recorded
portion is played back.
+ : to go forward
– 7 : to go backward
Release EDITSEARCH to stop playback. If you press START/STOP, re-recording begins
from the point you released EDITSEARCH. You cannot monitor the sound.
Rec Review
You can check the last recorded section.
In the standby mode, press the – 7 side of EDITSEARCH momentarily.
The section you have stopped most recently will be played back for a few seconds, and
then your camcorder will return to the standby mode. You can monitor the sound from
the speaker or headphones.
Checking recordings
– END SEARCH/EDITSEARCH/Rec Review
EDITSEARCH
END SEARCH
To Next Page
Loading...
Need help?
General
