VIDEO OUT board
BD board
SENSOR board
TRANS board
POWER AMP board
JACK board
PANEL board
REMOTE board
1 STREAM LED board (RV20)
6 STREAM LED board (RV50/RV60)
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
•%: indicates tolerance.
•
f
: internal component.
• C : panel designation.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
•Voltage and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
•Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
no mark : FM
(): CD
[]: TAPE
•Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f : AM
E : PB (DECK A)
d : PB (DECK B)
G : REC (DECK B)
J : CD
c : digital out
L : VIDEO
for printed wiring boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• x : parts mounted on the conductor side.
• : Pattern from the side which enables seeing.
(The other layer’s patterns are not indicated.)
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
•Waveforms
– BD Board –
1
2
IC103
6
(A),
8
(C)
Approx.
160mVp-p
3
4
IC103
7
(B),
9
(D)
Approx.
160mVp-p
IC103
qg
(RFAC)
Approx.
1Vp-p
IC103
wk
(RFDCO)
Approx.
0.6Vp-p
– VIDEO Board –
1
33.8688MHz
IC505
<zb/>
(XTAO)
1.1Vp-p
2
29MHz
IC505
<x/n>
(CLKA)
0.6Vp-p
– PANEL Board –
1
2
8.64MHz
IC601
qg
(CF1)
32.768kHz
IC601
qs
(XT1)
1.2Vp-p
1Vp-p
To Next Page
Loading...
