52
GB
Check the network connection
(page 15) and the network settings
(page 44).
Depending on the usage
environment (including the wall
material), radio wave reception
conditions, or obstacles between the
system and the wireless LAN router,
the possible communication distance
may be shortened. Move the system
and the wireless LAN router closer to
each other.
Devices that use a 2.4 GHz frequency
band, such as a microwave,
BLUETOOTH, or digital cordless
device, may interrupt
communication. Move the unit away
from such devices, or turn off such
devices.
The wireless LAN connection may be
unstable depending on the usage
environment, especially while using
the BLUETOOTH function of the
system. In this case, adjust the usage
environment.
The wireless router you want is not
shown in the wireless network list.
Press BACK to return to the previous
screen, and try [Wireless Setup] again
(page 15). If the wireless router you
want is still not detected, select [New
connection registration] from the
network list, then select [Manual
registration] to input a network name
(SSID) manually.
No sound is heard from the
subwoofer.
The subwoofer is designed for
playback of bass sound. When the
input source does not contain much
bass sound, as is the case with most
TV programs, the bass sound may not
be audible.
Press SW + on the remote control
to increase the volume of the
subwoofer (page 21).
Set the night mode to [Off]. For
details, see “Enjoying Clear Sound
with Low Volume at Midnight
(NIGHT)” (page 20).
The remote control of this system
does not function.
Point the remote control at the
remote control sensor on the unit
(page 7).
Remove any obstacles in the path
between the remote control and the
system.
Replace both batteries in the remote
control with new ones, if they are
weak.
Make sure you are pressing the
correct button on the remote control.
The Control for HDMI function does
not work properly.
Check the connection with the
system (refer to the supplied Startup
Guide).
Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.
Subwoofer
Remote Control
Others
To Next Page
Loading...
