HVR-DR60
6-9
(6) The “Input Drive Data” dialogue appears.
Click “OK”.
Fig. 6-4-7
(7) The HDD check starts.
The “Worker thread start” message appears.
It takes approx. 10 minutes to check the HDD.
Fig. 6-4-8
(8) After the HDD check finishes normally, the “Worker thread is
done” message appears in the access log list.
Click “
×” to finish.
The dialogue below appears to confirm “finish”. Click “Yes”.
Fig. 6-4-9
(9) • Confirm that the time lag from “Write-Read Check” to “Read
Cheak” is less than “3 minutes and 30second”.
• Confirm that the time lag from “Read Cheak” to “Worker
thread is done.”is less than “5 minutes and 30second”.
Fig. 6-4-10
(10) Terminate by clicking “×”.
The dialogue below appears to confirm the termination. Click
“Yes”.
Then, the check software is quit.
Fig. 6-4-11
In case of abnormality
In case of abnormal check result is obtained, the message below
appears.
[Write NG, Start Block = xxxx, End Block = xxxx, Time = ‘xx’
msec]
Fig. 6-4-12
3. Confirm that no error exists.
4. Format the HDD.
Perform steps (1) to (10).
To Next Page