Help Guide
Interchangeable Lens Digital Camera
ILCE-1 α1
Self-timer Type: Self-timer(Single)
Shoots an image using the self-timer after a designated number of seconds have elapsed since the shutter button was
pressed. Use the 5-second/10-second self-timer when you are going to be in the picture, and use the 2-second self-timer
to reduce camera-shake caused by pressing the shutter button.
Menu item details
The mode determines the number of seconds until a picture is taken after the shutter button is pressed.
Self-timer(Single): 10 sec
Self-timer(Single): 5 sec
Self-timer(Single): 2 sec
Hint
Press the shutter button again to stop the count of the self-timer.
Select a drive mode other than
(Self-timer) by turning the drive mode dial to cancel the self-timer.
Set [Audio signals] to [Off] to turn off the beeping sound during the self-timer countdown.
To use the self-timer in bracket mode, select
(Bracket) by turning the drive mode dial, then select MENU →
(Shooting) → [Drive Mode] → [Bracket Settings] → [Selftimer during Bracket].
Related Topic
Audio signals
5-025-537-14(1)
Copyright 2021 Sony Corporation
Select (Self-timer) by turning the drive mode dial.
Turn the drive mode dial while holding down the drive mode dial lock release button.
1
MENU → (Shooting) → [Drive Mode] → [Self-timer Type] → [Self-timer(Single)] → desired mode.
The setting screen for [Self-timer Type] can be displayed by pressing the Fn button.
2
Adjust the focus and shoot the image.
The self-timer lamp flashes, a beep sounds, and a picture is taken after the designated number of seconds have
elapsed.
3
To Next Page
