Bottom
Fixing (M3) screw holes
Use M3 screws less than 4.5 mm (3/16 inches) long (Recommended tightening torque: 0.6 N・m).
If you use screws with dimensions other than those specified, you may not be able to secure this product firmly and may
damage it.
Fixing screw holes can be found in the following locations.
Front: 4 locations
Rear: 4 locations
Top: 4 locations
Sides: 2 locations on each side
Bottom: 4 locations
Tripod socket hole
Supports 1/4-20 UNC screws
Use a tripod, etc. with a screw less than 5.5 mm (7/32 inches) long (Recommended tightening torque: 2.0 N・m).
Otherwise, you cannot firmly secure the camera, and damage to the camera may occur.
1.
To Next Page
Loading...
