© 2015 Sony Corporation
4-587-126-11 (1)
Operate the unit from a computer that is connected to the same network as the unit.
Open a web browser on the computer,
enter the unit’s IP address in the address
bar, and press the Enter key.
Enter the user name and password in the
dialog box that appears, and click [OK].
The web control screen appears.
Use the following user name and password when logging in for
the first time.
User name: sonypcs
Password: sonypcs
The Initial Setup Wizard will appear when you log in. Configure
the necessary settings, and change the password. (The user
name cannot be changed.) After you log in again and agree
to the end-user license agreement, the unit will be ready for
operation.
Enter the IP address.
The factory default address is
“192.168.0.100.”
Enter the user name and password.
The user name is “sonypcs” or “pcsuser,” and the
password is configured by the administrator.
PCS-MCS1 HD MCU System
Quick Reference Guide
Operating the Unit
System Configuration Example
The unit allows you to hold conferences with up to 16 connected points.
PCSA-MPE2
PCS-MCS1Computer
Videoconferencing terminal
PCSA-MPE1
#1 #2 #16#5 #11#6 #12#3 #7 #13#9 #15#4 #8 #14#10
Optional software (not supplied) is required to connect to more than four points.
To Next Page
Need help?
General
