Adjustment Using the Menus
23
[Time Code Setting]
[Focus Assist Setting]
[WFM/ALM/Vector (waveform monitor,
audio level meter, and vectorscope) Setting]
[Aspect Marker] Selects the aspect ratio of the aspect
marker. You can select between [4:3]
and [Off].
[Center Marker] Sets to [On] for displaying the marker
which represents the center of the
picture. Sets to [Off] for not displaying.
[Area Marker] Selects the safe area size for the aspect
marker. When the aspect marker is set
to [Off], this menu selects the safe area
size for the effective screen area. You
can select from among [Off], [80%],
[85%], [88%], [90%], [93%], [95%].
[Marker Intensity] Sets the luminance to display the
[Aspect Marker], [Center Marker], and
[Area Marker]. You can select between
[High] and [Low].
Submenu Setting
[Time Code] Selects [On] to display the time code
and [Off] not to display.
[Format] Sets the time code format.
[VITC]: To display the time code in
VITC format.
[LTC]: To display the time code in
LTC format.
[Position] Sets the position of the time code
display. You can select between [Top]
and [Bottom].
[Transparency] Selects [Black] or [Half] (transparent)
for the background of time code display.
[Black]: The background becomes
black. Displayed image is hidden
behind the background.
[Half]: The background becomes
transparent. Displayed image
appears under the time code
display.
Submenu Setting
Submenu Setting
[Focus Assist] Selects [On] to use the camera focus
and [Off] not to use.
[Focus Mode] Switches the camera focus mode.
[Color]: Displays the intensified areas
of images with color selected in
the color setting below.
[Color]: Selects the displayed
intensified color from among
[Red], [Green], [Blue],
[Yellow], [White].
[Standard]: An image with
sharpened edges is displayed.
[Frequency] Sets the center frequency of the edge
sharpening signal. You can select from
among [Low], [Middle], [Middle High],
[High].
[Range] Sets the target of edge sharpening. You
can select from among [Narrow],
[Middle], [Wide].
[Gain] Sets the level of edge sharpening.
Submenu Setting
[Display] Select [On] to display the [WFM]
(waveform monitor), [ALM] (audio
level meter), or [Vector] (Vectorscope);
or [Off] not to display.
To Next Page
Loading...
