18
DOLBY NR
Searching for the beginning of a
track (AMS*)
During playback, turn the jog dial the same
direction as the ª or · indicator to go
forward. Turn the opposite direction to go
back. (Or press = or + on the remote.)
The search direction, + (forward) or – (back),
and number of songs being skipped (1~9)
appear in the display.
Example: searching forward 2 songs
* AMS (Automatic Music Sensor)
Notes
• The AMS function may not operate correctly
under the following circumstances:
– When the unrecorded space between songs is
less than 4 seconds long.
– If completely different information is recorded
on the left and right channels.
– When there are continuous sections of
extremely low level or low frequency sound
(like those of a baritone sax).
– When the unit is placed near a television. (In
this case, we recommend moving the unit
farther away from the television or turning off
the television.)
• Dolby NR is off and DIRECTION (A or RELAY)
is ß when the mains AC power supply is
switched off.
Playing a tape (continued)
To Do this
Stop play Press π (or p on the
remote).
Fast-forward Press ) on the remote
while playing the front side
or 0 while playing the
reverse side.
Rewind Press 0 on the remote
while playing the front side
or ) while playing the
reverse side.
Remove the cassette Press § .
Adjust the volume Turn VOLUME (or press
VOLUME +/– on the
remote).
Tips
• Pressing · or ª when the power is off
automatically turns the power on and starts tape
playback if there is a tape in the deck (One Touch
Play). When the system is in the Power Saving
Mode, the One Touch Play function does not
work.
• You can switch from another source to the tape
deck just by pressing · or ª (Automatic Source
Selection).
• If the tape you want to play is recorded with
DOLBY NR, you can reduce the noise by pressing
DOLBY NR so that “DOLBY NR” lights up.
To Next Page
Loading...
Need help?
General
