10
Connecting optional
AV components
To enhance your system, you can connect
optional components. Refer to the
instructions of each component.
Connecting audio
components
Select one of the following two connections,
depending on the equipment to be connected
and method of connecting.
Connecting an MD deck for digital
recording
You can record from CD into the MD deck
digitally by connecting an optical cable.
To the DIGITAL IN jack of the MD deck
Step 3: Presetting radio stations
(continued)
Note
You cannot record from a VIDEO CD to an MD
deck digitally. When you record from a VIDEO
CD to an MD deck, connect an optional audio
cable to the audio output. (See “Connecting an
MD deck for analog recording.”)
To change the AM tuning interval
The AM tuning interval is factory set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER/NEXT
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
To Next Page
Loading...
Need help?
General
