Chapter 11 Setup Menus
11-6 Chapter 11 Setup Menus
Item number Item name Settings
a)The channel condition indication appears under the timer
or status line (under the video playback level indication
during playback of an analog tape), in the format “V−A−”,
where the symbol following the “V” indicates the rotating
head condition for video channels and the symbol
following the “A” indicates the rotating head condition for
audio channels.
The following three symbols appear:
“−” (good)
“*” (fair)
“x” (poor)
013 525/625 SYSTEM
SELECT
11-3 Items in the Basic Setup Menu
Specify whether to enable switching between 525-line (NTSC) and 625-line (PAL)
modes.
off : Do not enable system switching.
on: Enable system switching.
Setting this item to “on” and switching the system enables the unit to operate in
the system switched to.
For the switching between 525/625-line modes, see page 11-4.
Notes
• For the basic and extended setup menus, separate settings are saved for 525-
line (NTSC) and 625-line (PAL) modes. When you switch systems, all menu
items change to the settings established in the new system. (These are different
from the settings for the mode before switching.)
• When the MSW-M2100/M2100E is used in 625-line mode or when the MSW-
M2100P/M2100EP is used in 525-line mode, analog tape can only be played
back in the simple playback mode.
012
a)
CONDITION DISPLAY
VIDEO MONITOR
Specifies whether to add a channel condition indication to superimposed text,
when “x1” is selected in menu item 011.
disable : Do not display.
ena1: Display an indication of both channel condition and tape time (remaining
time, etc.)
ena2: Display an indication of channel condition only
ena3: Display an indication of tape time (remaining time, etc.) only
023 LOCAL KEY MAP
When MAP is selected in menu item 006, the buttons that can be operated on the
control panel of this unit when it is being controlled by remote control from
another device can be selected from the following sub-items.
The settings of each sub-item are as follows.
DIS : Do not function.
ENA: Function.
Sub-item
1 STOP Select whether the STOP button functions.
2 PLAY Select whether the PLAY button functions.
3 STANDBY Select whether the STANDBY button functions.
4 EJECT Select whether the EJECT button functions.
5 JOG Select whether the JOG button functions.
6 SHUTTLE Select whether the SHUTTLE button functions.
7 VAR Select whether the VAR button functions.
8 FF/REW Select whether the F FWD and REW buttons function.
9 PREROLL Select whether the PREROLL button functions.
10 F-KEY Select whether the F1 to F6 buttons function.
11 AUDIO/MONITOR Select whether the audio signal buttons function.
12 OTHERS Select whether the ENTRY, IN, OUT, AUDIO IN, AUDIO OUT, TRIM+, TRIM-,
GS-MARK, GS-LIST, DELETE, and DMC EDIT buttons function.
(Continued)
To Next Page
Loading...
