Sony MZ-N10 Using

Notes on using the recorder together with a dry
battery
• It is recommended that you use the recorder only after
attaching the dry battery case and inserting a new dry battery
into the case.
•If the recorder has not been used for a few days after the battery
became exhausted and “LOW BATT” appeared in the display, the
recorder may not operate even after you insert a new dry battery or
attach the dry battery case with a battery in it. If this happens,
charge the built-in rechargeable battery and then try using the
recorder again.
Notes on charging
•When the recorder has not been used for a long time, the charge
lamp will not light up immediately after you place the recorder on
the USB cradle. If this happens, leave the recorder on the cradle
for a few minutes, and then take the recorder off and reset it on
the cradle. Also make sure that the BUILT-IN BATTERY switch
at the rear of the recorder is set to ON.
• It is recommended that you charge the built-in rechargeable battery
immediately after “LOW BATT” appears in the display.
• Set the BUILT-IN BATTERY switch at the rear of the recorder to
OFF if the recorder will not be used for a long time.
For details, refer to the operating instructions supplied with the
recorder.
Sony Corporation  2003 Printed in Japan 0-429-743-11(1)
MZ-N10

Sony MZ-N10 Specifications

Power

power input	DC In, 6V (USB Cradle Input)
power requirements	AC-ES605 AC Adaptor (supplied)
battery type	Embedded Lithium-Ion Battery (supplied)

Battery

battery life (SP Mode)	Embedded 8.5 hrs
battery life (LP2 Mode)	Embedded 11 hrs
battery life (LP4 Mode)	Embedded 14 hrs

Audio Specifications

sampling frequency	44.1 kHz
frequency response	20-20, 000Hz +/-3dB
data compression method	ATRAC®/ATRAC3™

Weight and Dimensions

weight	3 oz (84g)
dimensions	3 1⁄8" x 3" x 9⁄16" (78.5 x 73.3 x 13.8mm)
color	Silver