EasyManua.ls Logo

Sony MZ-N505 OpenMG Jukebox NOTES on installing & operating - Troubleshooting Common Issues; Recorder overwrites existing materials

Sony MZ-N505 OpenMG Jukebox NOTES on installing & operating
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55-GB
The recorder does
not work or works
poorly.
The disc is record-protected (SAVED appears).
, Slide the tab (page 50).
Recording level is too small to record (when recording
manually).
, Pause the recorder and adjust the recording level.
A Premastered MD is inserted (PbONLY appears) when
recording.
, Insert a recordable MD
You tried to turn group mode on while setting the program.
, Turn group mode on before setting the program.
The recorder
overwrites existing
materials when
record.
The record starting-position setting (R-Posi) is set to
FrHere.
, Set R-Posi setting to Fr End.
The recorder does
not work while
connected to the
computer.
The computer does not recognize the recorder.
, Verify that the recorder is correctly connected.
, Install the driver correctly into your computer.
, Install the OpenMG software into your computer first, and
then connect the recorder.
No SIG appears in
the display when
recording from a
portable CD player.
There is no digital signal from the portable CD player.
, When recording digitally from a portable CD player, use the
AC power adaptor and disable the anti-skip function (such as
ESP) on the CD player (page 19).
There is no recording
on the MD after a
recording operation.
The AC power adaptor was unplugged or a power outage
occurred during recording.
The lid does not
open.
The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
The lid is not firmly closed.
, Close the lid until it clicks. Then press OPEN to open the lid.
No sound comes
through the
headphones/
earphones.
The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to i.
Volume is too low.
, Adjust the volume by pressing VOL +/.
The plug is dirty.
, Clean the plug.
Volume cannot be
turned up.
AVLS is o n.
, Set AVLS to OFF (page 46).
An MD is not played
normally.
Playback mode is changed.
, Change to the normal play.
Symptom Cause/Solution

Table of Contents

Related product manuals