63-GB
FULL • You tried to enter more than 200 letters to label a single track or disc.
• You tried to enter a total of more than 1,700 letters for track or disc
names.
, Enter a shorter name for the track, group, or disc (page 37), or set
the “LPStmp” setting to “OFF” so that “LP:” is not added at the
beginning of the track name (page 26).
NoCOPY • You tried to make a copy from a disc that is protected by the Serial
Copy Management System. You cannot make copies from a digitally
connected source which was itself recorded using digital connection.
, Use analog connection instead (page 25).
NoDISC • You tried to play or record with no disc in the recorder.
, Insert an MD.
No SIG • The recorder could not detect digital input signals.
, Make sure that the source is connected firmly (page 16).
PbONLY • You tried to record or edit on a pre mastered MD (Pb stands for
“playback”).
, Insert a recordable MD.
SAVED • You tried to record or edit on a MD with the tab in the record-protect
position.
, Slide the tab back (page 50).
SORRY • You tried to erase the track mark at the beginning of the first track.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to press X or T MARK during synchro-recording.
• You tried to turn on the group function while programming.
, Turn the group function on before programming.
TEMP • Heat has built up in the recorder.
, Let the recorder cool down.
Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
TrFULL • Track number 254 has been reached.
, Erase unnecessary tracks (page 44).
TrPROT • You tried to record or edit on a track that is protected from erasing.
, Record or edit on other tracks.
• You tried to edit a track that has been checked out from a computer.
, Check the track back in to the computer and then edit.
Error message Meaning/Remedy
To Next Page
Loading...
