74-GB
NO SIGNAL • The recorder could not detect digital input signals.
, Make sure that the source is connected firmly (page 19).
P/B ONLY • You tried to record or edit on a pre mastered MD (P/B stands for
“playback”).
, Insert a recordable MD.
PROTECTED • You tried to record or edit on a MD with the tab in the record-protect
position.
, Slide the tab back (page 61).
REC ERR • Recording was not correctly done.
, Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is
not a standard disc.
, Try recording again with another disc.
READ ERR • The recorder cannot read the disc information correctly.
, Reinsert the disc.
SORRY • You tried to erase the track mark at the beginning of the first track.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to press X or T MARK during synchro-recording.
• You tried to turn on group function while programming.
, Turn the group function on before programming.
TEMP OVER • Heat has built up in the recorder.
, Let the recorder cool down.
TOC Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
TOC ERR • The recorder cannot read the disc information correctly.
, Insert another disc.
, If it is no problem to erase all the contents of the disc, erase all
(page 55).
TR FULL • Track number 254 has been reached.
, Erase unnecessary tracks (page 55).
TrPROTECT • You tried to record or edit on a track that is protected from erasing.
, Record or edit on other tracks.
• You tried to edit a track that has been checked out from a computer.
, Check the track back in to the computer and then edit.
Error message Meaning/Remedy
To Next Page
Loading...
