35-GB
Checking the remaining
recordable time
You can check the remaining time, track
number, etc. when recording or during
stop. Group-related items appear only
when a track with group settings is played
and then stopped.
When you operate the recorder with the
supplied remote control, use the buttons
and controls shown in parentheses.
1 While the recorder is recording or
stopped, press MENU (EDIT for 2
seconds or more).
2 Press . or > (flip the lever
towards > or .) repeatedly
until “DISPLAY” flashes in the
display, and then press ENTER
(ENTER) again.
3 Press . or > (flip the lever
towards > or .) repeatedly
until the information you want flashes
in the display.
Each time you press > (flip the
lever towards .), the display
changes as follows:
Display window on the recorder
On A
LapTime
The elapsed time of the current
track.
r
RecRemain
The remaining recordable time.
r
GP Remain
The remaining time after the current
track in a group.
r
AllRemain
The remaining time after the current
location.
Note
Items may not be selectable depending on
group mode’s on/off status or the recorder’s
operating status.
4 Press ENTER (ENTER).
The information selected in step 3
appears in A and B.
A — track number, track name,
group name, or disc name.
B — the information selected in step
3.
Note
Items may appear differently depending on
group mode’s on/off status, the recorder’s
operating status, or the recorder settings.
z
If you want to check the playing position or
track name while playing, see page 40.
ENTER
EDIT
>/.
MENU
ENTER/
./>
B
To Next Page
Loading...
