12
Recording in sync with
the source player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
1 Set INPUT switch to ”OPT1” or
”OPT2”.
Set it to match the input jack
connected to the source.
2 Slide SYNCHRO REC to ON.
“SYNC” appears in the display.
3 Press and slide REC to the right.
The recorder stands by for recording.
4 Play the source sound.
The recorder starts recording when it
receives the playing sound.
z
Various ways of recording
SYNCHRO REC
REC
CD players,
etc.
To stop recording, press p.
z
•You cannot pause manually during
synchro-recording.
•When there is no sound from the player for
more than 3 seconds during synchro-
recording, the recorder goes into the
standby mode automatically. When the
sound comes from the player again, the
recorder resumes synchro-recording. If the
recorder is kept in the standby mode for 5
minutes or longer, the recorder stops
automatically.
Notes
•Do not switch SYNCHRO REC after step 2.
Recording may not be done properly.
•When recording in monaural, follow steps
1 and 2 of “Recording in monaural for
double the normal recording time” (page
14) before synchro-recording .
INPUT
0% 50% 100%
LEVEL
0246812
LEFT
RIGHT
–db504030 20
SYNC
To Next Page
Loading...
