18
A Connecting to audio L/R jacks
This connection uses a stereo amplifier’s
(receiver’s) two front speakers for sound.
You can enjoy the surround function that creates
virtual speakers from two stereo speakers. Select
from “Surround1,” “Surround2,” or “Surround3”
of the surround effects (page 35).
Surround 1
Surround 2
Surround 3
B Connecting to a digital audio input jack
Use this connection if your AV amplifier
(receiver) has a Dolby
*1
Digital, DTS
*2
, or MPEG
audio decoder and a digital input jack. You can
enjoy the surround effect of Dolby Digital (5.1ch),
DTS (5.1ch), or MPEG audio (5.1ch).
*1
Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol are trademarks of
Dolby Laboratories.
*2
“DTS” and “DTS Digital Out” are trademarks of
Digital Theater Systems, Inc.
z Hints
• For correct speaker location, see the operating
instructions supplied with the connected components.
• Digital audio signal can also be output when playing a
VHS tape.
Notes
• During DVD recording, you cannot hear VHS sound
by pressing VIDEO, as the DIGITAL AUDIO OUT
jacks will output DVD audio signals only.
• After you have completed the connection, make the
appropriate settings in Easy Setup (page 22). If your
AV amplifier (receiver) has an MPEG audio decoder
function, set “Digital Out” – “MPEG” to “MPEG” in
the “Audio” setup (page 103). Otherwise, no sound or
a loud noise will come from your speakers.
• With a coaxial or optical digital connection, you cannot
use the virtual surround effects of this recorder.
• This recorder does not support Linear PCM playback
with 3 channels or more.
• When outputting from the DIGITAL AUDIO OUT
jacks, you cannot switch the bilingual sounds on a
DVD-RW (VR mode) by pressing (audio).
Virtual speaker
To Next Page
Loading...
