Troubleshooting
227
Table of Contents
Wireless Connectivity
Wi-Fi connection
The Reader does not connect to the Wi-Fi network.
The network feature could not be turned on because the
remaining battery power is too low. Charge the Reader for
a few minutes, and then try again.
Make sure that Wi-Fi is turned on and check the signal
strength of the access point.
Scan the available access points in the vicinity and select a
new one.
Make sure that the security method (WEP/WPA), the static
IP address and the proxy settings are correct.
The access point is using an unsupported security method
or encryption key.
Public Wi-Fi networks may require a user ID and password.
In this case, you must enter a correct user ID and password
to establish a network connection.
The access point has the MAC address filter enabled. To
check the MAC address, press the (Home) button
tap
[Applications]
[Settings]
[About]
[Device
Information]. Make sure that this MAC address is accepted
by the access point.
The Wi-Fi network settings of the access point are not
To Next Page
Loading...
