13
Example: To set up a Philips’ TV
1 See the tables in the supplied
“Component Code Numbers,”
and find the four-digit code
number for the desired
component.
If more than one code number is
listed, use the number that is listed
first.
For example, to set up a Philips’ TV,
you would use the code number 8086.
The first digit of the component code
number means the component
category (TV, VCR, etc.). For further
details, see the tables in the supplied
“Component Code Numbers.”
2 While pressing COMMANDER
OFF, press %.
“SET” appears on the Mode Display
key.
3 Press the PRESET key.
“PRESET” appears on the Mode
Display key.
4 Select the desired component by
pressing the Component Select
button or the Label key.
To change the Label keys, press the
OTHER button repeatedly. Each time
you press the OTHER button, the
display of the Label keys changes as
follows.
When the desired component is
selected, the component name
previously preset to the Component
Select button or the Label key (in this
case, TV), and the four-digit
component code number previously
set to the component are displayed.
“0” - “9,” “ENT,” “CLEAR” and
“POWER1” flash.
Continued
COMMANDER
OFF
TV
To Next Page
Loading...
Need help?
General
