30
Controlling the Volume of Visual
Components Connected to an
Audio System (continued)
1 While pressing COMMANDER
OFF, press %.
“SET” appears on the Mode Display
key.
2 Press the Mode Display key (SET)
twice.
Each time the SET key is pressed, the
Label keys changes as in Step 2 on
page 11.
“MODE” appears and flashes on one
of the Label keys.
3 Press the MODE key.
“MODE” appears on the Mode
Display key.
4 Press the VOLUME key.
“VOLUME” appears on the Mode
Display key, and “AMP” flashes on
one of the Label key.
5 To change the volume control
setting of visual components (TV,
STB, STB2, STB3, VCR, VCR2,
VCR3, DVD, DVD2, DVD3, LD
and CABLE) press the AMP key.
With a beep sound, the volume
control setting of visual components
is switched to the amplifier.
To return the volume control setting
to “TV”, press the TV key.
COMMANDER
OFF
MODE
To Next Page
Loading...
