36
Executing a Series of Commands
— System Control Functions
(continued)
To erase all programmed
commands for all SYSTEM
CONTROL buttons and
corresponding Label keys
1 Follow Steps 1 - 3 in the left.
2 While pressing the DEL key, press
the SYSTEM key.
3 Press the YES key.
“REALLY?” stays lit, and “YES” and
“NO” flash.
If you press the NO key
The display returns to Step 1.
4 Press the YES key.
While erasing, “c c c c” stays lit.
When all settings programmed for the
Component Select buttons and
corresponding Label keys are erased,
“OK” is displayed with a beep sound.
If you press the NO key
The display returns to Step 4.
While erasing, “c c” stays lit. When
erasing finishes, “OK” is displayed
with a beep sound.
7 Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
COMMANDER
OFF
SYSTEM
To Next Page
Loading...
Need help?
General
