67
To check the execution of the
timer programme or set the
timer programme to the standby
mode
1 Follow Steps 1 - 3 on page 61, 62.
2 Press the TEST key or the ON/
OFF key.
TEST: You can check the timer
programme setting by transmitting
the Timer Macro signals.
ON/OFF: The display turns as below.
With a beep sound, “ON” appears,
and the Commander enters the timer
standby mode. The display returns to
Step 2 on page 61.
To reset the timer standby mode,
press the ON/OFF key again.
3 Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
COMMANDER
OFF
Continued
To Next Page
Loading...
