Sony RM-BR300 - Remote Control Unit - Connections and Operations; Connecting a RS-232 C Camera; Connecting Cables

Connections and Operations
Connections
9
GB
Connections and Operations
Connections
This section focuses on the connection examples for the
BRC-300/300P camera. For connections with other
cameras, refer to the Operating Instructions supplied
with the camera you will connect.
Connecting a Camera Equipped
with a VISCA RS-232C Connector
1 Connect this unit to the camera using the RS-232C
connecting cable supplied with this unit.
2 Connect this unit to an AC outlet using the supplied
AC power adaptor and AC power cord.
Note
When using the VISCA RS-232C connectors, check that
the DIP switch on the bottom of this unit (page 8) is set
to RS-232C.
Connecting cables
Use the following connecting cable to connect devices
in this system.
RS-232C cable
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON
IN VISCA RS-232C OUT
!
VISCA RS-422
1 2 3 4 5 6 7 8 9
DC IN
12V
R
VIDEO S VIDEO
RS-232C cable (supplied)
(SONY: 1-590-879-3X)
VISCA RS-232C IN
to AC outlet
VISCA RS-232C
DC IN 12V
AC power cord
(supplied)
to AC outlet
AC power adaptor
MPA-AC1 (supplied)
Camera BRC-300/300P
Cable Part No. Number
RS-232C cable
(3m (10feet))
1-590-879-3X 1