81
INVALID GW ADDRESS
PLEASE CHANGE GW ADDR
There is a device configured with a
default gateway that cannot be used on
the network.
This message is displayed when the network
connection settings are checked.
Change the default gateway setting of the
de
vice.
DETECTED SAME MAC ADD
B
UT DIFFERENT IP ADD
The MAC address of a detected camera
is the same as a registered camera, but
the IP address of the camera and the
address in the camera table are
different.
This message may be displayed when making
ca
mera assignments using AUTO IP SETUP
>ASSIGN CAM.
Change the settings so that the IP address of
t
he camera matches the IP address in the
camera table.
INVALID IP ADDRESS
PLEASE CHANGE IP ADDR
A camera configured with the same IP
ad
dress as the unit was detected.
This message may be displayed when making
camera assignments using AUTO IP SETUP
>SETUP IP.
Change the IP address of the camera or the
u
nit so that they are different.
DUPLICATE IP ADDRESS
D
ETECTED IN NETWORK
Duplicate IP address settings were
detected.
This message may be displayed when making
camera assignments using AUTO IP SETUP
>ASSIGN CAM.
There are devices with the same IP addresses
on
the network. Configure the IP addresses so
that they are different.
SAME IP ADDRESS ALREADY
IN
CAM TABLE
The IP address of the detected camera is
already registered in the camera table.
This message may be displayed when making
camera assignments using AUTO IP SETUP
>ASSIGN CAM.
The IP address of the detected camera is the
s
ame as the IP address of a camera registered
in the camera table. Change either one of the
IP addresses.
DIFFERENT IP NETWORK
SET SAME SEGMENT
The segment of the IP address of the
de
tected camera is different from the
segment of the unit.
This message may be displayed when making
camera assignments using AUTO IP SETUP
>ASSIGN CAM.
A camera cannot be recognized if the segment
o
f the IP address of the unit is different. Set the
segment of the IP address of the camera to the
same segment as the IP address of the unit.
ALREADY REGISTRATION IN
TH
IS GP/CAM
A camera is already assigned to the
target GROUP and CAMERA buttons.
This message may be displayed when
changing camera assignments for the GROUP
and CAMERA buttons.
A camera is already assigned to the target
GRO
UP and CAMERA buttons. Assign to
different GROUP and CAMERA buttons.
DUPLICATE IP ADDRESS ON
TH
E CAMERA TABLE
An attempt was made to change an IP
address to an IP address that is
registered in the camera table.
This message may be displayed when
changing the IP address of a camera.
Use different IP addresses.
DUPLICATE IP ADDRESS IN
TH
E NETWORK
An attempt was made to change an IP
address to an IP address that is used by
a device on the network.
This message may be displayed when
c
hanging the IP address of a camera.
Use different IP addresses.
CAMERA BUSY The camera could not accept the change
in
settings.
This message may be displayed when
changing the IP address of a camera.
The camera is busy and cannot accept the
cha
nge in settings.
NO RESPONSE There was no response from the
ca
meras.
This message may be displayed when
changing the IP address of a camera.
There are no cameras on the network or the
ca
meras are not responding.
Message Meaning Cause and remedy
To Next Page
Loading...
