18
Using the List s
St arting m acro play
1 Press FUNCTION.
The function list appears.
C D
TUNER
PHONO
2 M ove the easy scroll key to select “M ACRO 1” or
“M ACRO 2”, then press the key to enter the
selection.
The IR codes appear in the display window as they are
performed.
Notes
• Pressing any of the following buttons during a macro play
operation will cancel the macro play sequence before it is
complete.
–AV ?/1
– ?/1
– SYSTEM STANDBY
– SOUND FIELD
– FUNCTION
– SET UP
• When the Macro Play function does not work properly, set
“WAIT TIME” between each operation.
Perf orm ing Several Comm ands in Sequence
Aut om at ically (M acro Play)
Other Operations
Turning the backlight on or off
Each time you press a button on the remote, the backlight
turns on. If you do the procedure below to turn off the
backlight, you can make the batteries last longer.
1 Press SET UP.
The set up list appears.
2 M ove the easy scroll key to select “BACK LIGHT,”
then press the key to enter the selection.
The BACK LIGHT list appears .
<BACK LIGHT>
ON
OFF
3 M ove the easy scroll key to select “ON” or “OFF,”
then press the key to enter the selection.
Clearing all the cont ents of rem ot e‘s
memory
Be sure to turn on the receiver and point the remote
tow ards the receiver w hen performing the follow ing
procedure.
1 Press SET UP.
The set up list appears.
2 M ove the easy scroll key to select “ALL CLEAR”,
then press the key to enter the selection.
3 M ove the easy scroll key to select “YES”, then press
the key to enter the selection.
“CLEAR OK?” appears.
4 M ove the easy scroll key to select “YES” again,
then press the key.
All the contents of the remote’s memory (i.e., all the
programmed data) are cleared.
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
