16
GB
Operation
The Macro Play function lets you link several IR codes in
sequential order as a single command. The remote
provides 3 macro lists (MACRO 1, 2 and 3). You can
specify up to 10 IR commands for each macro list.
1 Touch FUNCTION.
The FUNCTION screen appears.
2 Touch .
The MACRO screen appears.
When
does not appear in the FUNCTION screen,
use the JOG DIAL to scroll through the list until it is
displayed, and then touch it.
• Touch SEND to operate Macro Play. The current command
is displayed in black. The finished commands are grayed
out.
• To cancel Macro Play, touch CANCEL. When Macro Play is
not operating, touching CANCEL returns to the
FUNCTION screen.
Performing Several Commands in Sequence Automatically
(Macro Play)
Notes
• For some models, the receiver/amplifier cannot operate the
Macro Play commands as the time between each command is
too short. In this case, set “WAIT TIME” between each
command. To set “WAIT TIME”, refer to “Macro Play setting”
on page 26 and 27.
• For some makers other than Sony, there are some commands
that cannot be used in Macro Play.
BOX Number
Send key
Category
Command
Condition
SENDING: Outputting the
command
Done!: Outputting is
finished
To Next Page
Loading...
Need help?
General
