24
GB
Operation
Registering the connected components
The following procedure lets you set up the commander
to operate the components connected to the receiver/
amplifier.
When carrying out this operation, make sure that the receiver/
amplifier’s power is on, and be sure to point the commander’s
transmitter/receiver section toward the display on the receiver/
amplifier.
1 Touch SETUP.
The SETUP screen appears.
2 Touch FUNCTION&USER IR.
The FUNCTION&USER IR screen appears.
3 Select the function that you wish to register (Ex:
VIDEO1).
To display other items, use the JOG DIAL or touch 4
or $ to scroll through the list.
The FUNCTION&USER IR:CATEGORY screen
appears.
The following explanations allow you to adjust various
settings and customize the commander’s operating
environment.
Displaying the SETUP screen
To adjust the operating environment, first display the
SETUP screen.
Touch SETUP.
The SETUP screen appears.
Adjusting the Commander’s Operating Environment
SETUP
To Next Page
Loading...
Need help?
General
