2
GB
Understanding the 2 way remote system
This commander operates under a 2 way remote system.
With the 2 way remote system, the component responds
to signals sent from the commander by sending additional
signals (information about the status of the component,
text data, etc.) back to the commander. Thus, operations
are performed as a result of communication between the
commander and the component.
When using a home entertainment system comprised of
several components compatible with the 2 way remote
system, please restrict 2 way remote system operation to a
single component. Generally, the 2 way remote system is
turned off on all components except for the receiver/
amplifier.
If you would like to turn off the receiver/amplifier’s 2
way remote system, refer to “Setting up the 2 way
remote” in the operating instructions supplied with the
receiver/amplifier.
Precautions
CAUTION (Lithium battery)
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Discard
used batteries according to the manufacturer’s
instructions.
On operation
Before connecting other components, be sure to turn off and
unplug the receiver/amplifier.
On cleaning
Clean the cabinet, panel and controls with a soft cloth slightly
moistened with a mild detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such as alcohol or
benzine.
If you have any question or problem concerning your
commander, please consult your nearest Sony dealer.
Component
Commander
About This Manual
• The following icon is used in this manual:
z Indicates hints and tips for making the task easier.
Before You Use the
Commander
To Next Page
Loading...
Need help?
General
