17
GB
5 Press and hold the button
on the other remote control,
until “OK” appears in the
display.
During data transfer, “LEARN”
stops flashing.
After data transfer is complete,
“OK” appears in the display.
Then, the Commander returns
to its state in Step 3.
If “NG” flashes twice, and
the component name
flashes again
Learning was unsuccessful. Try
again from Step 4.
Continued
-3S
R
ARNLE
CV
-3S
O
ARNLE
K
-3S
R
ARNLE
CV
remote control
of component
data transfer
complete
during data
transfer
6 Repeat Steps 4 and 5 to
“teach” functions to other
buttons.
7 Select “EXIT,” then press
the Jog dial to finish
Learning.
To cancel Learning
Press SET.
Notes
• If you do not perform Learning steps
within 30 seconds at any point during
the process, the LEARN mode ends.
• If you do not perform Step 5 within
10 seconds after Step 4, the
Commander returns to its state in
Step 3.
• You cannot teach to the Jog dial and
the SET button.
• If the memory of the commander is
full, “OVER” flashes, and the
Commander returns to its state in
Step 3. Erase the already “learned”
function (page 21) and start over from
the beginning.
If the Commander does not
seem to be working
If the “learned” button does not
operate properly, “teach” once again.
(For example, if the volume becomes
very loud after pressing 2 + only
once, noise may have interfered during
the Learning procedure.)
If you set a component code
after “learning” a signal
If you have programmed any signal on
a button by the Learning function, that
signal will work even after you set a
component code.
Note on the REC z signal
You can only “teach” to one button at a
time. Therefore you cannot teach a
sequential button operation (for
example REC z + N) to a single
button on your Commander.
To Next Page
Loading...
Need help?
General
