20
GB
3 Press and hold the input
select button (e.g. VIDEO or
CD etc.) on your amplifier’s
remote control, until “OK”
appears in the display.
During data transfer, “LEARN”
stops flashing.
After data transfer is complete,
“OK” appears in the display.
Then, the Commander returns
to its state in Step 2.
If “NG” flashes twice, and
the component name
flashes again
Learning was unsuccessful. Try
again from this Step.
Operating Non-Preset
Components
— Learning Function (continued)
4 Select “EXIT,” then press
the Jog dial to finish
Learning.
To cancel Learning
Press SET.
MPA
DEO1
ARNLE
IV
MPA
O
ARNLE
K
MPA
DEO1
ARNLE
IV
VIDEO
remote control
of amplifier
data transfer
complete
during data
transfer
To Next Page
Loading...
Need help?
General
