1
Ver. 1.1 2007.04
SERVICE MANUAL
US Model
Canadian Model
AEP Model
UK Model
E Model
SPECIFICATIONS
HOME THEATRE SPEAKER SYSTEM
SS-FRF3H
SA-FT3H/WFT3/
SS-CNF3H/FRF3H
SS-CNF3H
AUDIO POWER SPECIFICATIONS (US, CND model)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz; rated 150 watts per
channel minimum RMS power, with no more than 10% total
harmonic distortion from 250 milliwatts to rated output.
SS-FRF3H (front/surround speakers)
Speaker system 2 way, magnetically shielded
Speaker units Woofer: 10 cm, cone
type
Tweeter: 2.5 cm, balanced
dome type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 W
Sensitivity level 84 dB (1 W, 1 m)
Frequency range 140 Hz – 50,000 Hz
Dimensions (w/h/d) Approx. 120 × 360 × 32 mm
with table top stand Approx. 120 × 372 × 32 mm
(Diameter of base: 190 mm)
Mass Approx. 0.9 kg
with table top stand Approx. 0.95 kg
SS-CNF3H (center speaker)
Speaker system 2 way, magnetically shielded
Speaker units Woofer: 8 cm (× 2), cone
type
Tweeter: 2.5 cm,
dome type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 W
Sensitivity level 84 dB (1 W, 1 m)
Frequency range 150 Hz – 50,000 Hz
Dimensions (w/h/d) Approx. 430 × 88 × 32 mm
with table top stand Approx. 430 × 98 × 66 mm
Mass Approx. 0.85 kg
with table top stand Approx. 0.9 kg
• SA-FT3H is composed of following models.
COMPONENT MODEL NAME
FRONT/SURROUND SPEAKER SS-FRF3H
CENTER SPEAKER SS-CNF3H
SUBWOOFER SA-WFT3
SA-WFT3
– Continued on next page –
9-879-802-02
2007D04-1
© 2007.04
Sony Corporation
Home Audio Division
Published by Sony Techno Create Corporation
To Next Page
Need help?
General
