37
GB
[BT]
(BLUETOOTH
settings)
[POWER]
(BLUETOOTH
Power)
You can turn the BLUETOOTH function on or off.
•[
ON]: Turns the BLUETOOTH function on.
• [OFF]: Turns the BLUETOOTH function off.
Note
When the BLUETOOTH function is set to off, the BLUETOOTH
input is skipped while selecting input by pressing INPUT.
[STANDBY] When the system has pairing information, you can turn the
system on and listen to music from a BLUETOOTH device,
even when the system is in standby mode, by setting the
BLUETOOTH standby mode to on.
•[
ON]: BLUETOOTH standby mode is enabled.
• [OFF]: BLUETOOTH standby mode is disabled.
Note
While the BLUETOOTH standby mode is on, standby power
consumption increases.
[AAC CODEC] You can enjoy high-quality sound if AAC is enabled and your
device supports AAC.
•[
ON]: Enables AAC codec.
• [OFF]: Disables AAC codec.
[SYSTEM]
(System
settings)
[IR REPEATER] • [ON]: Remote signals for the TV are sent from the rear of
the bar speaker.
•[
OFF]: Turns off the function.
For details, see “When the TV Remote Control does not
Work” (page 16).
[AUTO
STANDBY]
•[ON]
: Turns on the auto standby function. When you do not
operate the system for about 20 minutes, the system
enters standby mode automatically.
• [OFF]: Off.
[VERSION]
(Version
information)
The current firmware version information of the system
appears in the front panel display.
[RESET]
(Resetting the
system)
[ALL RESET] You can reset the system settings to the factory default. For
details, see “Resetting the System” (page 45).
[UPDATE]
(Updating the
system)
[START] You can start a software update after connecting the USB
memory on which the software update file is stored to the
system. When there is a software update available, we will
notify you on the following website:
https://www.sony.eu/support
Notes
• Before updating, make sure that the subwoofer is turned
on and connected to the system.
• You can update the software of the system by pressing and
holding and the BLUETOOTH button on the bar speaker
for 7 seconds.
[CANCEL] Returns to the upper layer [UPDATE].
Items Function
To Next Page
Loading...
