Sony SBH60 - Getting started; Preparing to use your headset with a Bluetooth device; Using your headset in wired mode

Getting started
Preparing to use your headset with a Bluetooth® device
Before you can start using your headset with a Bluetooth® device, you need to pair
the headset with the Bluetooth® device manually using Bluetooth® or automatically
using NFC.
To manually pair your headset with a Bluetooth® device
1
Bluetooth® device: Make sure the Bluetooth® function is turned on.
2
Turn off your headset.
3
Headset: Press and hold down the Power key until a blue notification light
starts flashing rapidly.
4
Bluetooth® device: Scan for Bluetooth® devices, then select SBH60 in the list
of available devices.
5
Bluetooth® device: Follow the pairing instructions that appear on the screen.
To automatically pair your headset with a Bluetooth® device
1
Bluetooth® device: Make sure that the NFC function is turned on and that the
screen is active and unlocked.
2
Place the Bluetooth® device over your headset so that the NFC detection area
of each device touches the other.
3
Bluetooth® device: Follow the pairing instructions that appear.
The device used in this illustration is for illustration purposes only and may not accurately
depict the actual device used.
To reconnect to a paired Bluetooth® device
•
Briefly press the Call key.
Using your headset in wired mode
You can also use your Stereo Bluetooth® Headset SBH60 as a wired headset, that is,
in wired mode. When you insert an audio cable into the 3.5 mm audio jack, the
headset gets disconnected from any paired Bluetooth® devices and turns off
automatically. You can then use the headset in wired mode, that is, using a wired
connection that does not require the headset to be turned on.
7
This is an Internet version of this publication. © Print only for private use.