Sony SEQ-711 - WARNING; OWNERS RECORD; Precautions

OWNER’S RECORD
The model and serial numbers are located at the rear.
Record serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony
dealer regarding this product.
Model No.SEQ-711
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
Serial No.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the prod-
uct's enclosure that may be of suffi-
cient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompa-
nying the appliance.
* The graphical symbols are on the rear enclosure.
CAUTION
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
INFORMATION
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, use, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
~ Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Precautions
On safety
¢ Operate the unit only on 120 V AC, 60 Hz.
* The unswitched socket outlets remain live, independently
of power switch setting, at ali times when the unit is
connected to the AC power supply.
* Should any solid object or liquid fall into the unit, unplug
it and have it checked by qualified personnel before
operating it any further.
e Unplug the unit from the wall outlet if it is not to be used
for an extended period of time. To disconnect the cord,
pull it out by grasping the plug. Never pull the cord itself.
e AC power cord must be change only at the qualified
service shop.
On operation
Before making program source connections, be sure to turn
the power switch off and unplug the unit.
On cleaning the cabinet
Clean the cabinet, panei and controls with a soft cloth lightly
moistened with mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent such as alcohol
or benzine.
For the customers in the U.S.A
For detailed safety precautions, see the leaflet “IMPORTANT
SAFEGUARDS".
If you have any question or problem concerning your unit,
please consult your nearest Sony dealer.