Preparation
Assigning the IP Address to the Camera
9
If the information bar appears, click on the bar and select
Install ActiveX Control….
If “Internet Explorer – Security Warning” appears, click
Install.
The installation of ActiveX Control starts. When
installation is completed, the main viewer or the Motion
detection menu appears.
Configuring Windows Firewall
SNC toolbox may not operate correctly depending on
the configuration of Windows Firewall. (No cameras are
shown in the list even if they are detected.) In this case,
confirm the Windows Firewall configuration as follows:
Example: In case of SNC toolbox
To turn Windows Firewall off
1
Select Control Panel from the Start menu of
Windows.
2
Select Security Center of the working field.
3
Select Off in the Windows Firewall dialog.
The camera will be displayed in the list.
To turn Windows Firewall on
1
Select Control Panel from the Start menu of
Windows.
2
Select Security Center of the working field.
3
Select Exceptions in the Windows Firewall dialog.
4
Click Add Program….
Program name
To Next Page
Loading...
