– 19 –
4. STEP 4
When set to this step, it indicates “ 4” on the 7 segments LED (D217), and keep beeps DTMF tone.
Each time the [SLOW, REPEAT] key is pressed, DTMF tone is change.
5. STEP 5
When set to this step, the 7 segments LED (D217) goes off.
In this step, it will be recording mode from line input (LINE jack: J1) every time.
It indicates depending on input condition on the 7 segments LED (D217) as follows.
Busy tone ON: “b “
Busy tone OFF: “ “ no indication
VOX ON: “ “ no indication
VOX OFF: “ n”
6. STEP 6
When set to this step, it indicates “ 6” on the 7 segments LED (D217).
In this step, when detects bell signal from line input (LINE jack: J1), it respondents automatically.
When it respondents automatically, indicates so that “
– –
”→ “
– –
” → “
– –
” → … on the 7 segments LED (D217) as follows.
[Initializing the DSP]
1. Power on with pressing the [ERASE] key for 4 seconds.
2. When start initializing, it beeps key-touch-tone.
3. Then finish initializing, it beeps confirm tone, and blinks “PF” on the 7 segments LED (D217).
To Next Page
