Sony STR-D715 - Page 10

Listening toAAAatching a Program Source
Labeling the Program Source
You can create and input a name for each function button as
you like (except TUNER). You can use up to 11 letters for
each name.
1 Select the program source (except TUNER).
2 Press DISPLAY if "INDEX MODE" is not
displayed.
3 Press DPC MODE repeatedly until the INDEX
indicator lights up.
4 Create an index name.
® 1
L_
i
To select a letter (A to Z) or number (1 to 9), press a
or V.
To change the position, press < or >.
5 Repeat steps 1 to 3 for ali other program
sources you want to assign an index name
to.
To Turn Off the Power at the Desired Time
(The Sleep Timer Function)
This function can be operated only with the remote
commander*
This receiver has the sleep timer function. With this
function, you can turn off the power automatically at the
desired time by designating the turn-off time*
Press SLEEP on the remote commander when the power is
on* Each time SLEEP is pressed, the designating time is
displayed in the following order: 2 hours — ► 1 hour and 30
minutes — ► 1 hour — ► 30 minutes — ► SLEEP OFF.
When the sleep timer function is turned on, the display
becomes dim*
SUEP
To change the turn-off time
1 Press SLEEP* The sleep time is displayed*
2 Press A or v to change the sleep time* The sleep time is
changed by 1 minute. It can be changed up to 5 hours*
To check the remaining time of the sleep timer
Press SLEEP* The remaining time is displayed*
If you input an already stored source under any
other index name
Only the last selected index name will be valid* Each
program source can be stored under only one index name*
To switch the original function name display and
created index name display
Each time the DISPLAY is pressed, the selected function
name (which corresponds to the function selector) and the
created index name are alternately displayed*
10