154
GB
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the status of the system by the message.
See the following table to solve the problem. If
any problem persists, consult your nearest
Sony dealer.
PROTECTOR
The upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Remove the object covering the upper panel
of the receiver and turn on the power again.
For other messages, see “Message list after
auto calibration measurement” (page 50),
“DIGITAL MEDIA PORT message list”
(page 60) and “Message list” (page 71).
Reference sections
To clear the memory of the
simple remote commander
After removing the batteries, do not use the
remote for a few minutes.
Refer to the following web site for details of
the latest information on the receiver.
For customers in the United States and
Canada:
http://www.sony.com/essupport
For the customers in Europe:
http://support.sony-europe.com/quickjump/
STR
Error messages
Clearing the memory
To clear See
All memorized settings page 42
Multifunction remote
commander
page 146
About support information
To Next Page
Loading...
