27
Getting Started
Sound Adjustment
2) The adjustment of this parameter does not affect the
level of the bass frequencies sent to the subwoofer
from the front, center, or rear channels via the bass
redirection circuitry. Setting this parameter to 0dB
outputs the full LFE signal at the mix level
determined by the recording engineer. Selecting
MUTE mutes the sound of the LFE channel from the
subwoofer. However, the low frequency sounds of
the front, center, and rear speakers are output from
the subwoofer according to the setting of each
speaker (page 20).
3) Setting this parameter to OFF reproduces the sound
track with no dynamic range compression. STD
reproduces the sound track with the full dynamic
range as intended by the recording engineer. MAX
provides a dramatic compression of the dynamic
range.
Resetting customized sound fields to the
factory settings
1 If the power is on, press POWER to turn off the
power.
2 Hold down SOUND FIELD and press POWER.
“SURR CLEAR!” appears in the display and all the
sound fields are reset at once.
To Next Page
Loading...
