EasyManua.ls Logo

Sony STR-DE345 Operating Instructions (STR-DE345) - Specifications

Sony STR-DE345 Operating Instructions (STR-DE345)
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Additional Information
20
GB
Specifications
Amplifier section
Full mute
+6 dB at 70 Hz
±6 dB at 100 Hz and
10 kHz
87.5 - 108.0 MHz
75 ohms, unbalanced
10.7 MHz
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 2 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3 %
Stereo: 0.5 %
45 dB at 1 kHz
30 Hz - 15 kHz dB
60 dB at 400 kHz
10 kHz interval*
530 - 1710 kHz
9 kHz interval
531 -1710 kHz
Loop antenna
450 kHz
50 dB/m (at 1,000 kHz or
999 kHz)
54 dB (at 50 mV/m)
0.5 % (50 mV/m,
400 Hz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
Rated Power
Output at
Stereo Mode
Reference
Power Output
Frequency
response
Inputs
Outputs
Inputs
Outputs
System
Power
requirements
Power
consumption
Dimensions
Mass (Approx.)
Supplied
accessories
General
VIDEO, TV/SAT,
5.1 CH/DVD:
1 Vp-p 75 ohms
VIDEO, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complementary
SEPP
127/220 V AC, 60 Hz
200 W
17 x 5
6
/8 x 12 inches
(430 x 145 x 304 mm)
7.3 kg (16 lb 2 oz)
See page 4
Video section
(8 ohms at 1 kHz, THD
0.7%)
80 W + 80 W
(8 ohms at 1 kHz, THD
0.7%)
Front: 80 W + 80 W
Center: 80 W
Rear: 80 W + 80 W
TV/SAT, CD, MD/
TAPE, VIDEO, 5.1 CH/
DVD:
10 Hz - 50 kHz dB
MD/TAPE REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
SUB WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
Muting
BASS BOOST
TONE
Tuning range
Antenna terminals
Intermediate
frequency
Sensitivity
Usable sensitivity
S/N
Harmonic
distortion at 1 kHz
Separation
Frequency
response
Selectivity
Tuning range
Antenna
Intermediate
frequency
Usable sensitivity
S/N
Harmonic
distortion
Selectivity
Tuner section
FM stereo, FM/AM superheterodyne tuner
+0.5
–2
AM tuner section
Design and specifications are subject to
change without notice.
FM tuner section
* You can change the AM tuning interval
between 9 kHz and 10 kHz. Turn off the
receiver and press ?/1 (power) for more
than 4 seconds until “INITIAL” appears.
1) After tuning in any AM station, turn
off the receiver.
2) Hold down PRESET TUNING + button
and press the ?/1 (power) button.
“9k STEP” appears.
To change to 10k Step, repeat step 1 and 2
until “10k STEP” appears. Note that all
preset stations, index names and sound field
are cleared after you make the procedure
above.
S/N
85 dB
CD,
5.1 CH/
DVD,
MD/TAPE,
TV/SAT,
VIDEO
Impedance
50
kilohms
Sensitivity
150 mV
+0.5
–2