Sony STR-DE495 Service Manual (English)

Other manuals for Sony STR-DE495

Service Manual54 pages

Easy Setup Guide1 page

Questions and Answers:

J
Joseph HowellAug 19, 2025
What to do if there is no sound from a specific component on my Sony STR-DE495 Stereo Receiver?
- J
  Jack ClementsAug 20, 2025
  If you're not getting sound from a specific component connected to your Sony Stereo Receiver, first, check that the component is correctly connected to the appropriate audio input jacks. Then, ensure the cords are fully inserted into the jacks on both the receiver and the component. Finally, make sure you've selected the correct component on the receiver.
L
Lacey BatesAug 21, 2025
How to enable surround effect on my Sony STR-DE495?
- M
  Michael SandersAug 21, 2025
  To enable the surround effect on your Sony Stereo Receiver, ensure that the sound field function is turned on by pressing MOVIE or MUSIC.
M
Melissa ZamoraAug 25, 2025
What to do if my Sony Stereo Receiver has no sound?
- L
  Linda MooreAug 25, 2025
  If your Sony Stereo Receiver isn't producing sound, or the sound is very low, try these steps: First, ensure that all speakers and components are securely and correctly connected. Verify that both the receiver and all connected components are powered on. Check the MASTER VOLUME to ensure it's not set to “VOL MIN”. If you're using the remote, press MUTING to deactivate the muting function. For STR-DE595 models, confirm the SPEAKERS button is correctly set (refer to page 22). Also, make sure headphones are disconnected. Finally, if a short circuit occurred, turn off the receiver, resolve the short-circuit, and then turn it back on.
K
Katelyn McfarlandAug 26, 2025
Why is my Sony STR-DE495 remote not working?
- M
  Marc AveryAug 26, 2025
  If your Sony Stereo Receiver remote isn't working, try these solutions: Ensure you're pointing the remote directly at the remote sensor on the receiver. Verify you've selected AV2 as the command mode of the receiver (page 36). Remove any obstructions between the remote and the receiver. If the batteries are weak, replace them with new ones. Ensure you've selected the correct input selector on the remote. If the remote is set to operate the TV only, select a different source or component before using it with the receiver. Note that (STR-DE495 only) The MULTI CH button on the remote is not available.
A
Ashley DavisAug 27, 2025
How to fix humming or noise in my Sony Stereo Receiver?
- K
  Kevin SnyderAug 28, 2025
  To address severe humming or noise in your Sony Stereo Receiver, make sure the speakers and components are securely connected. Ensure connecting cords are away from transformers, motors, and at least 3 meters from TVs or fluorescent lights. Try moving your TV further from the audio components. Also, clean the plugs and jacks with a cloth slightly moistened with alcohol.
T
Tyrone WoodAug 29, 2025
How to improve FM reception on my Sony STR-DE495 Stereo Receiver?
- S
  sfuentesAug 29, 2025
  To improve FM reception on your Sony Stereo Receiver, use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna.
B
Brittany RoseAug 31, 2025
Why can't I tune into radio stations on my Sony STR-DE495?
- J
  Jennifer WoodSep 1, 2025
  If you're having trouble tuning into radio stations on your Sony Stereo Receiver, first, check that the antennas are securely connected. If the signal strength is weak, use direct tuning. Ensure you've set the tuning interval correctly, especially when tuning AM stations with direct tuning. If no stations are preset, preset them (page 31). Finally, press DISPLAY to show the frequency in the display.
D
donnabakerSep 2, 2025
What to do if one front speaker isn't working on my Sony STR-DE495 Stereo Receiver?
- J
  Jesus DaltonSep 2, 2025
  If you're not getting sound from one of the front speakers on your Sony Stereo Receiver, connect headphones to the PHONES jack to see if sound is output (page 22). Check that all the cords are fully inserted into the jacks on both the receiver and the component. Also, verify the connection of the front speaker that isn't producing sound.
J
jennifer88Sep 4, 2025
Why are the left and right sounds unbalanced on my Sony Stereo Receiver?
- B
  Bradley RobinsonSep 5, 2025
  If the left and right sounds are unbalanced or reversed on your Sony Stereo Receiver, first, check that the speakers and components are connected correctly and securely. If that doesn't solve the issue, adjust the balance parameters in the LEVEL menu.
S
Stephanie HillSep 7, 2025
What to do if there is no picture on my Sony Stereo Receiver?
- S
  Stephanie WattsSep 7, 2025
  If there's no picture or the picture is unclear on your TV screen or monitor when using your Sony Stereo Receiver, select the correct input selector on the receiver. Also, set your TV to the appropriate input mode. Finally, try moving your TV away from the audio components.

Sony STR-DE495 Specifications

General

Dimensions	430 x 145 x 298 mm
Total Harmonic Distortion	0.09%
Speaker Load Impedance	8 ohms
Video Connections	Composite
Tuner Type	Digital
Inputs	4 audio, 2 video
Outputs	1 Audio Out, 1 Video Out, 1 Headphone Out
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Tuning Range	FM
Preset Stations	30