Additional Information
25
Specificat ions
Audio power specifications
POWER OUTPUT AND TOTAL
HARM ONIC DISTORTION
With 8-ohm load, both
channels driven, from 20
a)
-
20,000 Hz, rated 100 w atts
per channel minimum RM S
power, with no more than
0.09 %
b)
total harmonic
distortion from 250
milliwatts to rated output.
STR-SE491:
a) 40 Hz
b) 0.5%
VIDEO, TV/SAT, 5.1
CH/DVD:
1 Vp-p 75 ohms
VIDEO, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complementary
SEPP
120 V AC, 60 Hz
220 W
STR-DE535/SE491:
2 switched,
total 120 W/ 1A Max
STR-DE435:
1 switched,
total 120 W/1A Max
430 x 157 x 366 mm
(17 x 6
1
/8 x 14
5
/8
inches)
STR-DE535:
11.1 kg (24 lb 6 oz)
STR-DE435:
11.0 kg (24 lb 3 oz)
STR-SE491:
11.2 kg (24 lb 9 oz)
STR-DE535/DE435:
(8 ohms at 20 Hz – 20 kHz
less than 0.09% total
harmonic distortion)
100 W + 100 W
STR-SE491:
(8 ohms at 40 Hz – 20 kHz
less than 0.5% total
harmonic distortion)
100 W + 100 W
STR-DE535/435:
(8 ohms at 1 kHz, THD
0.8 %)
Front: 100 W/ch
Center*: (Pro Logic Mode)
100 W
Rear*: 100 W/ch
STR-SE491:
(8 ohms at 1 kHz, THD
0.5%)
Front: 100 W/ch
Center*: 100 W
Rear*: 100 W/ch
PHONO: RIAA
equalization curve
± 0.5 dB
(except STR-DE435)
TV/SAT, CD, MD/TAPE,
VIDEO, 5.1 CH/DVD:
10 Hz - 50 kHz ±1 dB
+0.5
–2
Inputs
Outputs
System
Power
requirements
Power
consumption
AC outlets
Dimensions
M ass (Approx.)
Amplifier section
Stereo mode
Surround mode
and 5.1 CH/DVD
mode
Frequency
response
MD/TAPE REC OUT:
Voltage: 250 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 250 mV,
Impedance: 10 kilohms
WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
Full mute
+8 dB at 70 Hz
±8 dB at 100 Hz and
10 kHz
87.5 - 108.0 MHz
75 ohms, unbalanced
10.7 MHz
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 2 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3 %
Stereo: 0.5 %
45 dB at 1 kHz
30 Hz - 15 kHz dB
60 dB at 400 kHz
FM tuner section
Tuner section
FM Stereo, FM /AM superheterodyne tuner
Tuning range
Antenna
Intermediate
frequency
Usable
sensitivity
S/N
Harmonic
distortion
Selectivity
10 kHz interval**
530 - 1710 kHz
9 kHz interval
531 - 1710 kHz
Loop antenna
450 kHz
50 dB/m (at 1,000 kHz)
54 dB (at 50 mV/m)
0.5 % (50 mV/m,
400 Hz)
At 10 kHz: 40 dB
At 9 kHz: 35 dB
Inputs
Impedance
50
kilohms
50
kilohms
S/N
86 dB
96 dB
PHONO
(except
STR-
DE435)
CD,
5.1 CH/
DVD,
M D/TAPE,
TV/SAT,
VIDEO
Sensitivity
4 mV
250 mV
AM tuner section
** You can change the AM tuning interval
between 9 kHz and 10 kHz. After tuning
in any AM station, turn off the receiver.
Hold down the PRESET TUNING +
button and press the 1/u (power)
button. All preset stations will be erased
when you change the interval. To reset
the interval, repeat the procedure.
Video section (except STR-SE491)
General
Outputs
M uting
BASS BOOST
TONE
Tuning range
Antenna
terminals
Intermediate
frequency
Sensitivity
Usable
sensitivity
S/N
Harmonic
distortion at 1
kHz
Separation
Frequency
response
Selectivity
(cont inued)
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
