23
EN
Additional information
Specifications
Audio power specifications
Amplifier section
S/N
Harmonic
distortion
Selectivity
54 dB (at 50 mV/m)
0.5 % (50 mV/m, 400 Hz)
At 9 kHz: 35 dB
At 10 kHz: 40 dB
Additional Information
*
You can change the AM tuning interval to 9
kHz. After tuning in any AM station, turn
off the receiver. Hold down the PRESET
TUNING + button and press the POWER
button. All preset stations will be erased
when you change the interval. To reset the
interval to 10 kHz, repeat the procedure.
Video section
Inputs
Outputs
General
System
Power
requirements
Power
consumption
AC outlets
Dimensions
Mass (Approx.)
Supplied
accessories
VIDEO 1, 2, TV:
1 Vp-p 75 ohms
VIDEO 1, 2, MONITOR:
1 Vp-p 75 ohms
Tuner section: PLL
quartz-locked digital
synthesizer system
Preamplifier section: Low-
noise NF type equalizer
Power amplifier section:
Pure-complimentary SEPP
120 V AC, 60 Hz
230 W
2 switched, total 120 W
430 x 157 x 355 mm
(17 x 6
1
/4 x 14 inches)
10.0 kg (22 lb 1 oz)
FM wire antenna (1)
AM loop antenna (1)
Remote commander
(remote) (1)
Size AA (R6) batteries (2)
Audio/Video cable (1)
Control S cord (1)
POWER OUTPUT
Stereo mode
Surround mode
Front
Center (only in
the DOLBY SUR
and THEATER
modes)
Rear
Dynamic power
output
Harmonic
distortion at
rated output
Frequency
response
8 ohms 20 Hz - 20 kHz,
120 W + 120 W
8 ohms at 1 kHz,
THD 0.8 %
120 W/ch
120 W
50 W/ch
160 W + 160 W, 8 ohms
225 W + 225 W, 4 ohms
Less than 0.3 %
PHONO: RIAA
equalization curve
±0.5 dB
CD, TAPE, DAT/MD,
VIDEO 1, 2:
10 Hz - 50 kHz dB
+0
–1
Impedance
50
kilohms
50
kilohms
S/N
(weighting
network,
input level)
75 dB**
(A, 2.5 mV)
82 dB**
(A, 250 mV)
Sensitivity
2.5 mV
200 mV
150 mV
PHONO
(MM)
CD
TAPE,
DAT/MD,
VIDEO 1,
2, TV
Inputs
** ‘78 IHF
Design and specifications are subject to
change without notice.
FM tuner section
Outputs
Muting
BASS BOOST
TONE
Tuning range
Antenna
terminals
Sensitivity
Usable sensitivity
S/N
Harmonic
distortion at
1 kHz
Separation
Frequency
response
Selectivity
+0.5
–2
AM tuner section
REC OUT VIDEO 1, 2
(AUDIO) OUT:
Voltage 150 mV,
Impedance 10 kilohms
MIX OUT
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
– 20 dB
+10 dB at 70 Hz
±8 dB at 100 Hz and
10 kHz
87.5 - 108.0 MHz
75 ohms, unbalanced
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 2 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3 %
Stereo: 0.5 %
45 dB at 1 kHz
30 Hz - 15 kHz dB
60 dB at 400 kHz
With 10 kHz interval*:
530 - 1710 kHz
With 9 kHz interval:
531 - 1710 kHz
Loop antenna
50 dB/m (at 1,000 kHz or
999 kHz)
Tuning range
Antenna
Usable sensitivity