Notes on HDMI connections
• An audio signal input to the HDMI IN jack
is
output from the speaker output jack and
HDMI OUT jack.
It
is
not output from any
other audio jacks.
• Video signals input to the HDMI INjack can
only be output from the HDMI OUT jack.
The video input signals cannot be output
from the VIDEO OUT jacks or MONITOR
OUT jacks.
• When you want to listen to the sound from
the TV speaker, set "AUDIO FOR HDMI" to
"TV+AMP" in the VIDEO menu (page 39).
If
you cannot play back multi channel
software, set to "AMP". However, the sound
will not output from the TV speaker.
• The multi/stereo area audio signals
of
a
Super Audio
CD
are not output.
• Audio signals (sampling frequency, bit
length, etc.) transmitted from an
HDMIjack
may be suppressed
by
the connected
component. Check the setup
of
the
connected component
if
an image is poor or
the sound does not come out
of
a component
connected via the HDMI cable.
• Sound may
be interrupted when the
sampling frequency, the number
of
channels
or the audio format
of
the audio output
signals from the playback component is
switched.
• When the connected component is not
compatible with copyright protection
technology (HDCP), the image and/or the
sound from the HDMI OUT jack may be
distorted or may not be output.
In this case, check the specification
of
the
connected component.
•
You
can enjoy multi channel Linear PCM
only with an HDMI connection.
• Set the image resolution
of
the playback
component to 720p, I080i or I080p when
you output96 kHz multi-channel sound over
an HDMI connection.
•
You
may need to make certain settings on the
image resolution
of
the player before you
can enjoy multi channel Linear PCM. Refer
to the operating instructions
of
the player.
• Refer to the operating instructions
of
each
component connected for details.
•
We
do not recommend using an HDMI-DVI
conversion cable. When you connect an
HDMI-DVI conversion cable to a DVI-D
component, the sound and/or the image may
not be output.
21
us
To Next Page
