Tuner
The
FM
reception
is
poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial)
as
shown below. Ifyou
connect the receiver to an outdoor antenna
(aerial), ground it against lightning.
To
prevent a gas explosion, do not connect the
ground wire
to a gas pipe.
Outdoor
FM
antenna (aerial)
Receiver
~-~
Ground wire
,..,-'"
FM
----1M'~
....j
cdl~A'
(not supplied)
+
To
ground
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength
of
the stations is too
weak (when tuning
in
with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset
or
the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 58).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
88
US
Remote commander
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles
in
the path between
the remote and the receiver.
• Replace all the batteries
in
the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
Error messages
If
there is a malfunction, the display shows a
message. You can check the condition
of
the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
Ifan error message appears while you perform
Auto Calibration, see "Error and warning
codes" (page 31) to solve the problem.
PROTECT
Irregular current is output to the speakers.
The receiver will automatically turn offafter
a few seconds. Check the speaker
connection and turn on the power again.
To Next Page
Loading...
