96
US
For details on each sound field type, see
“Enjoying a pre-programmed sound field”
(page 50).
Press 2CH/A.DIRECT, A.F.D.,
MOVIE, or MUSIC repeatedly.
The selected sound field type appears on the
display.
To select Enhanced Surround
Mode
1 Press AMP.
2 Press MENU.
3 Press V/v repeatedly to select
“<SURROUND>”, then press or b.
4 Press V/v repeatedly to select “E.SUR
MODE”, then press or b.
5 Press V/v repeatedly to select the enhanced
surround sound you want, then press .
Note
The selected Enhanced Surround Mode can only be
applied if you have selected “E.SURROUND” by
pressing A.F.D. repeatedly.
Press 2CH/A.DIRECT repeatedly to
select “A. DIRECT”.
For details on the tuner function, see “Tuner
Operations” (page 62).
Tuning radio stations
1 Press TUNER repeatedly to select the FM or
AM band.
You can also use INPUT SELECTOR on the
receiver.
2 Press TUNING + or TUNING –.
Press TUNING + to scan from low to high
frequencies, press TUNING – to scan from
high to low frequencies. The receiver stops
scanning whenever a station is received.
You can also press TUNING MODE on the
receiver to select “AUTO”, and then turn
TUNING +/– to select stations.
Selecting a frequency directly
(Direct Tuning)
1 After selecting the FM or AM band, press
D.TUNING.
2 Press SHIFT, then press numeric buttons to
enter the frequency.
3 Press .
1 Tune in the station that you
want to preset.
For details on the operation, refer to
“Tuning radio stations”.
2 Press SHIFT, then press
ENT/MEM.
You can also use MEMORY/ENTER on
the receiver.
“MEM” lights up for a few seconds.
Perform steps 3 and 4 before “MEM”
disappears.
Selecting a sound field type
Listening to the sound without
any adjustment (ANALOG
DIRECT)
Listening to the FM/AM radio
Presetting radio stations
To Next Page
Loading...
