1 Press TUNER repeatedly to
select the
FM
or
AM
band.
2 Press TUNING + or TUNING
-.
Press TUNING + to scan from low to
high; press TUNING - to scan from high
to low.
The receiver stops scanning whenever a
station
is
received.
Using the controls on the
receiver
1 Turn INPUT SELECTOR to select the FM
or AM band.
2 Press TUNING MODE repeatedly to select
"AUTO
T.".
3 Press TUNING + or TUNING
-.
In case of poor
FM
stereo
reception
If
the FM stereo reception
is
poor and "ST"
flashes
on
the display, select monaural audio
so that the sound will be less distorted.
Press FM MODE repeatedly until the
"MONO"
indicator lights up on the display.
To return to stereo mode, press FM MODE
repeatedly until the
"MONO"
indicator on the
display does not light up.
You can enter the frequency
of
a station
directly by using the numeric buttons.
1 Press TUNER repeatedly to
select the
FM
or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press D.TUNING.
3 Press the numeric buttons
to
enter the frequency.
Example
1:
FM 102.50 MHz
Select I
..
0
..
2
..
5
..
0
Example
2:
AM 1,350 kHz
Select I
..
3
..
5
..
0
4 Press ENTER.
You can also use MEMORY/ENTER on
the receiver.
Tip
If
you have tuned in an
AM
station, adjust the
direction
of
the
AM
loop
antenna
(aerial) for
optimum reception.
If you cannot tune
in
a station
Make sure you have entered the right
frequency.
If
not, repeat steps 2 to
4.
If
you
still cannot tune
in
a station, the frequency
is
not used
in
your area.
To Next Page
